AZ Barbeque.com
 photo 2741da0e-12e5-4649-a279-09b62ad0f40c_zpsow9b2o9p.jpg

UDS repaint advice needed

Discussion started on

eliellisone

  • Karma: 0
This looks absolutely perfect. All these tinny details are made with lot of background knowledge. I like it a lot. This was a useful post and I think it is rather easy to see from the other comments as well that this post is well written and useful.
#8 - May 17, 2012, 03:52:10 am
pizza pan

route66

  • Karma: 8
I have had a bunch of parts powder coated on projects by a guy in Maricopa, IMFLYIN, with great results. He even did the headers for my aircraft but used a ceramic coating which is said to resist up to 1400F. You might ask your powder coater if he can ceramic coat. I have crylon on my UDS and still looks great plus is easy to touch up when needed.
#7 - September 20, 2011, 12:13:27 am

AZWildcat

  • Karma: 22
I spoke with a powder coater today, he said it'll start to melt at 400 degrees, but under that you are fine. Now that's surface temp, not air temp. I don't think that my surface temps will get above that, unless I have a decent chicken fire! I'm tearing my UDS's down and getting them to him ASAP.
#6 - September 19, 2011, 09:37:36 pm
2 UDS's-Stoked
2 WSM's-Stoked
BWS Party-Stoked
22.5 Kettle to burn burgers and steaks.

Be kind, polite and courteous to everyone you meet, and ALWAYS have a plan to kill them.

Bob Smith

  • Karma: 4
Hey Dave, do you think powder coating will take the heat? Have you done that on any smokers? The reason I'm asking is I have a large smoker some of my students made, and I want to powder coat it. I've use engine paint but not real happy with it. 
#5 - September 19, 2011, 09:20:30 pm
1 small BGE
FEC 100
BCS CBJ
KCBS CBJ

bobsmith@azbarbeque.com

AZWildcat

  • Karma: 22
Thanks Dave...ill make some calls!
#4 - September 19, 2011, 08:16:56 am
2 UDS's-Stoked
2 WSM's-Stoked
BWS Party-Stoked
22.5 Kettle to burn burgers and steaks.

Be kind, polite and courteous to everyone you meet, and ALWAYS have a plan to kill them.

azkitch

  • Karma: 5
I looked up sandblasting; found a place that did mine for $20...outside only. I think you can get 'em powder coated for under $50.
#3 - September 19, 2011, 06:36:14 am
CBJ # 53779
For cooking, lower and slower. For spices, mo' hotter, mo' better. Habaneros rule!

AZWildcat

  • Karma: 22
Has anyone stripped their UDS to repaint it? Any advice or tips on getting the old paint off, other than just sanding?
#2 - September 16, 2011, 06:16:04 pm
2 UDS's-Stoked
2 WSM's-Stoked
BWS Party-Stoked
22.5 Kettle to burn burgers and steaks.

Be kind, polite and courteous to everyone you meet, and ALWAYS have a plan to kill them.

Members:

0 Members and 1 Guest are viewing this topic.


 photo 8a62c7f1-1fe7-46d7-8d33-bf16a670f332_zpsi4pk0fim.jpg